Slotted Stand

Enter Slot size for the material you are using. Read Instructions below for determining Slot Size.

Red=Cut

Green = Use on screen to verify size uploaded correctly in laser software, then delete size squares.

Assembly:

Glue Slotted Rectangle to Bottom of Backer with slot opening pointed down. Place long flat end in slot pointy end up, and short flat end along bottom surface it will sit on. Shelf Sitter will sit at a slight angle.

How to determine your slot size -

Using 1/8" material (acrylic, double sided MDF, wood) use Cuttle's Slot Size Tester (see link below) to determine what size to set your slot thickness value.

Next preform a test cut using the Slot Test Square (link below). This will allow you to test the actual fit of the value obtained from the slot size tester. Repeat test cut, if needed, until you get a good snug, but not forceful, fit. Once satisfied, enter that value in the slot thickness box.

Use Cuttle's Slot Size Tester to determine the slot thickness to enter into this program:

https://cuttle.xyz/@cuttle/Slot-Size-Tester-npTv5htPWyr8

Use Cuttle's Slot Test Square to determine a snug fit before cutting entire pattern.

https://cuttle.xyz/@cuttle/Slot-Size-Test-Squares-kzCWo9euCscX

I suggest for 1/8" material starting to start testing around at 0.114 inch and 0.115 inches.